Support
Set up and troubleshoot DeckBridge
Four settings in Syndicate, once. DeckBridge opens the same steps on first launch, and you can reopen them from the panel’s Setup guide or Settings › Setup Guide….
Set up Syndicate’s OSC
When it’s working, the panel shows CONTROLLER ● CONNECTED and FEEDBACK ● LIVE.
Settings → OSC
Turn OSC INPUT ENABLED on. The listen port is
9090.Settings → OSC Feedback
Set DEST IP to
127.0.0.1(or this Mac’s address if Syndicate runs on another Mac) and PORT to9096.Settings → OSC Feedback → Subscriptions
Turn on these subscriptions:
- Playing
- PlayPending
- Loaded and TrackInfo
- Position/Progress
- TempoSlider/TempoSliderEnabled
- Cues
- BPM/Sync
- Loop
Settings → MIDI
Turn the LC6000 PRIME’s MIDI input off in Syndicate. Otherwise Syndicate’s own mapping and DeckBridge would both react to every button.
Troubleshooting questions
Why do the LEDs stay dark when the controller works?
DeckBridge lights the controller from Syndicate’s OSC feedback. Check step 2 (DEST IP and PORT 9096) and that every subscription in step 3 is on. The panel’s Why no LEDs? line says which part is missing.
How do I switch between decks 1 to 4?
Use the LC6000’s own deck layers: Shift + deck select. DeckBridge follows the layer, releases anything held on the old deck and repaints the lights. To drive one fixed deck instead, turn off Follow controller layers in Settings and pick the deck in the panel.
Why does nothing happen when I press buttons?
Quit any other DJ app that was using the LC6000 PRIME first, then power-cycle the controller: some apps switch its MIDI mode until it restarts. Then check Diagnostics › MIDI Monitor: each button press should show up there.
Can Syndicate run on another Mac?
Yes. Set the Syndicate host in DeckBridge’s Settings to that Mac’s IP address, and set Listen on to All networks. macOS asks once for local-network permission; allow it, or no feedback arrives.
Can I try it without a controller?
Yes. Click Demo controller: Off in the panel. A scripted controller plays against a simulated session, with nothing sent to the network.
Contact support
Email deckbridge@ericdahl.dev. If you can, include what the panel shows and the Copy details text.